The basic principle of partition
Structure: a simple mechanism consisting of a combination of a cam and a turret, providing a variety of types of intermittent movement.
Transmission: mechanism to stop the movement of the way to stop, stop when you do not need any locking element can be positioned。
Movement: due to the precise design of the mechanism, the driving device is running smoothly and without vibration and noise。
The segmentation accuracy of the segmentation is determined by the accuracy of the various parts, and the basic accuracy is 30 seconds。
Performance: the special design of the cam curve, so that the split device in the high-speed operation to reduce the impact between the cam and the roller。
Curve: because of the different uses of the required curve: one, the deformation ladder type curve two, the deformation of the sine curve of three, the deformation curve。
Transmission: mechanism to stop the movement of the way to stop, stop when you do not need any locking element can be positioned。
Movement: due to the precise design of the mechanism, the driving device is running smoothly and without vibration and noise。
The segmentation accuracy of the segmentation is determined by the accuracy of the various parts, and the basic accuracy is 30 seconds。
Performance: the special design of the cam curve, so that the split device in the high-speed operation to reduce the impact between the cam and the roller。
Curve: because of the different uses of the required curve: one, the deformation ladder type curve two, the deformation of the sine curve of three, the deformation curve。
Deformed trapezoid curve（M.T CURVE）
Deformation trapezoid curve is today the most widely used for mechanical automatic speed cam curve, gradually replaced by cable and for indexing cam, the characteristics for the maximum acceleration (AM) value is small, so if a more accurate processing, good application in high-speed cam。
Deformation sine curve（M.S CURVE）
This curve is a very balanced and smooth curve, because of the continuity of the curve and the maximum acceleration (AM) value, so it is the most dangerous situation for the unknown or changing of the load.。
Deformation constant velocity curve（M.C.V CURVE）
From the following diagram, the deformation velocity curve can be used in the case of constant velocity motion. However, the maximum acceleration (AM) value of the curve is too large, and the inertia is large. Therefore, it should be avoided.
上一條:Cam segmentation feature
下一條:没有了
下一條:没有了
